mwillems wrote: ↑23 Nov 2022, 08:27
SmallSoldier wrote: ↑23 Nov 2022, 00:22
the EDGE wrote: ↑23 Nov 2022, 00:08
Yes, but what we’ve seen so far is McLaren making aero development, limited to its existing chassis concept,
Now they have the opportunity to change the chassis, to what extent will they choose to do so, and will that lead to a new aero concept. I mean, and its unlikely but still an example, they could choose to peruse a Mercedes philosophy if they now wanted
The latest update (Singapore) implied a Chassis change, that’s why only Lando had it there and then Daniel in Japan… I’m sure that based on time constraints and been in the middle of the season didn’t allow them to implement all the changes they would have liked.
Read that for example a clear change would be on trying to raise the back of the car a bit more in order to allow additional suspension travel and therefore more compliance from it, that was one of the challenges this year in the sense that the car was designed to run pretty flat, which involved a very rigid rear suspension setup (to avoid it from bottoming out) and the necessity to raise the car a bit more than what they would have wanted in order to avoid both bottoming and porpoising… I don’t think we will see rake like in the previous generation, but the concept and the Tunnel design will probably have that in mind.
The Singapore update wasn't chassis related, but the floor that they tested and did not race recently was only fully compatible with a higher rear, which this car cannot run.
So the team have made clear that they will raise the rear in the new car by showing that design. Alongside those sidepods, it seems that they have chosen the general direction of Red Bull, but I suppose that could change.
From Piers Thynne in a McLaren article:
"In June and July, we were in aerodynamic development, and it started to show enough promise for us to create more detail on this from a planning perspective. We spent a lot of time in July making sure that the performance step was enough because the scope of work and cost was high. The operational side of the team was going into a lot of detail to be certain and de-risk all aspects because the scope of work was so vast, and it involved taking the chassis out of service.
"This was a bonded chassis change, so we take the chassis back to its raw state and re-bond the brackets, the radiator ducts, the side pod uppers and everything else back on it. It was a considerable effort, and like everything we do, it's all about collaboration and teamwork."
It wasn’t a new chassis but a modification of the existing one, clearly there was movement of certain components required, ergo a change in the chassis… I may be misinterpreting it, but that’s how I read it.