The wording here suggests not…Ryar wrote: ↑31 Jan 2022, 16:10Another concept model. There are a few places where I am seeing that there is a possibility of S-duct, fed via nose. Is this still possible?
https://pbs.twimg.com/media/FKb5oX3XoAE ... name=large
3.6.1 Nose
Bodywork declared as “Nose” must:
a. LiewithinRV-CH-NOSE.
b. InanyXplane,containnomorethanasingleclosedsectionwhichmusthaveno external concave radius of curvature. Between XF= -950 and XA=0, the part of this section which is visible from above, must:
i. be a tangent continuous curve
ii. be tangent to the Z-axis at its outermost extremity
iii. have no radius of curvature smaller than 50mm at XA=0 which may reduce to a minimum radius of curvature of 20mm forward of XA=0
The provisions of this Article must be satisfied when considering both sides of the car.
3.6.2
3.6.3 3.6.4
c. In any Y plane, contain only a single section which, if inboard of Y=150, must be open.
d. Bearrangedsuchthat,whenviewedfromabove,nopartofRS-CH-NOSE,maybe visible.
The following will be exempt from the above:
e. Thecameras(position2)andmountingbracketsdefinedinArticle8.17.7
f. A single aperture for the purpose of driver cooling, such an aperture having a maximum surface area of 1500mm2 when measured on the untrimmed Nose and being situated forward of the section referred to in Article 13.6.1 (a)
This is the wording of the regulations.
Apologies for the poor formatting (it seems to be a C&P issue)