It still looks like the pull rod connect below the chassis, can it be angled horizontally at the bottom somehow?
Look at the vent on the lower side of the floor towards the back half of it. I wonder if airflow is going in or out of that ventorganic wrote: ↑21 Feb 2024, 10:17Good angle of floopr edge
https://pbs.twimg.com/media/GG2LZhkWwAA ... &name=orig
Highlight it please?trinidefender wrote: ↑21 Feb 2024, 10:22Look at the vent on the lower side of the floor towards the back half of it. I wonder if airflow is going in or out of that ventorganic wrote: ↑21 Feb 2024, 10:17Good angle of floopr edge
https://pbs.twimg.com/media/GG2LZhkWwAA ... &name=orig
organic wrote: ↑21 Feb 2024, 10:23Highlight it please?trinidefender wrote: ↑21 Feb 2024, 10:22Look at the vent on the lower side of the floor towards the back half of it. I wonder if airflow is going in or out of that ventorganic wrote: ↑21 Feb 2024, 10:17Good angle of floopr edge
https://pbs.twimg.com/media/GG2LZhkWwAA ... &name=orig
Look above the FAI rent~a~jet decal on the left side of the floororganic wrote: ↑21 Feb 2024, 10:23Highlight it please?trinidefender wrote: ↑21 Feb 2024, 10:22Look at the vent on the lower side of the floor towards the back half of it. I wonder if airflow is going in or out of that ventorganic wrote: ↑21 Feb 2024, 10:17Good angle of floopr edge
https://pbs.twimg.com/media/GG2LZhkWwAA ... &name=orig
Not a vent but probably where they place telemetry equipmentTomsky wrote: ↑21 Feb 2024, 10:25https://i.imgur.com/UhfWpJk.jpegorganic wrote: ↑21 Feb 2024, 10:23Highlight it please?trinidefender wrote: ↑21 Feb 2024, 10:22
Look at the vent on the lower side of the floor towards the back half of it. I wonder if airflow is going in or out of that vent