Yeah, that's nonsense. Clearly the sidepods are huge in reality.
To me it seems like a shadow/reflection that moves around as the car turns.
vorticism wrote: ↑09 Jan 2026, 20:49Confirmed on Audi’s car:vorticism wrote: ↑30 Dec 2025, 01:17Some guesses at what we’ll see in a couple of months:
Front pushrod. The front wing pressure distribution has changed. The largest part of the wing is now outboard, the opposite of the 2022 formula which had the largest part of the wing inboard. This will alter the flow fields between the front wheels.
...
Rake. The question is how much. The rear wing allowance seems small relative to the size of the front wing, and there are no beam wings. Use rake to increase overall downforce that is necessarily rearward of the front axle. That said--does rake conflict with using higher center of gravity pushrods at the rear.
...
https://i.postimg.cc/B6QXSC2J/Screensho ... -01-PM.png
Confirmed on Audi's car:vorticism wrote: ↑30 Dec 2025, 01:17Some guesses at what we’ll see in a couple of months:
...
Rear pushrod. The diffuser is not as tall but the onset of the diffuser remains in approximately the same location as the 2022 formula. It is perhaps better to not risk impinging upon it with pullrod mechanisms, although the higher CoG of a pushrod assembly could conflict with the use of rake.

Less efficient would point to more heat losses, especially considering that the power deficit is due mainly to the lower compression ratio (at least in theory). Making less power with similar fuel should result in more heat losses.PlatinumZealot wrote: ↑09 Jan 2026, 22:53[...]
Very conservative side pod openings. These engines will be less efficient and less powerful at the same time. So the big openings are interesting.
[...]
Couldn't this just be a sign of an A-car made for the barcelona test? That is, looking at reliability where they progressively close openings?matteosc wrote: ↑10 Jan 2026, 13:58Less efficient would point to more heat losses, especially considering that the power deficit is due mainly to the lower compression ratio (at least in theory). Making less power with similar fuel should result in more heat losses.PlatinumZealot wrote: ↑09 Jan 2026, 22:53[...]
Very conservative side pod openings. These engines will be less efficient and less powerful at the same time. So the big openings are interesting.
[...]
Not sure about how the lack of MGU-H affects heating.
I was wondering the same thing
Newey's modern era pull-rod also had the same concerns with impinging on the floor and the double diffuser. He somehow made it all fit inside the foot-print of the gearbox to nullify that issue. The reason why ground effect era moved the cars away from the pull-rod rear was perhaps the size of the tunnels but I think critically, the larger more complex suspension internals that were required. We saw that RedBull's pushrod in 2022 had complex, big parts to handle the loads and keep the ground effect floor in the narrow working range. For 2026, if the floor is not too sensitive I can see teams migrating towards a softer ride and more compact suspensions. Pull rod rear could become popular again. If it doesn't then it means the teams likely uncovered very strong benefits for the push-rod through lessons learnt in the Ground effect era.vorticism wrote: ↑10 Jan 2026, 02:32vorticism wrote: ↑09 Jan 2026, 20:49Confirmed on Audi’s car:vorticism wrote: ↑30 Dec 2025, 01:17Some guesses at what we’ll see in a couple of months:
Front pushrod. The front wing pressure distribution has changed. The largest part of the wing is now outboard, the opposite of the 2022 formula which had the largest part of the wing inboard. This will alter the flow fields between the front wheels.
...
Rake. The question is how much. The rear wing allowance seems small relative to the size of the front wing, and there are no beam wings. Use rake to increase overall downforce that is necessarily rearward of the front axle. That said--does rake conflict with using higher center of gravity pushrods at the rear.
...
https://i.postimg.cc/B6QXSC2J/Screensho ... -01-PM.pngConfirmed on Audi's car:vorticism wrote: ↑30 Dec 2025, 01:17Some guesses at what we’ll see in a couple of months:
...
Rear pushrod. The diffuser is not as tall but the onset of the diffuser remains in approximately the same location as the 2022 formula. It is perhaps better to not risk impinging upon it with pullrod mechanisms, although the higher CoG of a pushrod assembly could conflict with the use of rake.
https://i.postimg.cc/KzjJWjmY/k-TEp-Xh8-(1)-4.jpg
Yes, looking at it from the video from the Pitwall in neutral lighting the sidepod looks normal.vorticism wrote: ↑09 Jan 2026, 21:54Thanks for that.
Edit: Looking at more photos, it doesn't seem like there is anything unusual in that region. There appear to be normal louvers in the photo directly above your post, and a normal sized central cannon outlet. What is clear is that the sidepod has a pronounced curvature across the top.



Obviously, you're not well versed when it comes to AI. It does quite a decent job, a great one, in fact.
Teams will be restricted to a maximum of three days of running across the five-day test across January 26-30.
Yes. This is their private test in Barcelona (closed to the public). The choice of days is if there is fog, rain or other bad weather that they can choose a different day. It is likely that most teams will run on same days.
Just a note to say (to everyone, not picking on you), Imgur blocks all UK users, we just see a "content not visible in your region", so it's not ideal if you want everyone to see what you post. https://postimages.org is a good alternative imo.Shrieker wrote: ↑11 Jan 2026, 16:38Obviously, you're not well versed when it comes to AI. It does quite a decent job, a great one, in fact.