bjpower wrote:due to the low engine air intake is it possible a shark fin would not benefit the car as the reduced turbulence due to the lower air intakes?
The fin does not actually do anything while the car is in a straight line regradless of the air intakes.
It becomes active when the car is in a turn, especially highspeed turns.
And the smaller the engine scoop the more efficient the wing, as it will produce more as it gets more exposed to the oncoming air.
Imagine looking at the car dead on.
Now imagine the car pointing a few degrees to the left or right.
The profile of the fin has increased. This helps with some downforce(miniscule) and also with airflow.
What makes it good for McLaren is the way it works with the f=duct if the tube goes straight onto the rear wing.
Mercedes, I feel, need a full on shark fin that spans all the way to the rear wing /if it is to have any chance of solving its downforce/drag problem at the moment.
To be 13.4 Km/h behind Mclaren with the same engine is piss poor.
They have had 3 months to work on the F-duct and were supposedly using a variant of it this weekend. Problem is Mercedes have made the wind flow turn 90 degrees
twice(one up the one side ways before it reaches the staller).
This is highly inefficient and almost makes you wonder wether its worth the drag from the two scoops mounted either side of the tub.
I wait for Cananda, if it aint there then Mercedes should jack this year in.