Honda Power Unit Hardware & Software

All that has to do with the power train, gearbox, clutch, fuels and lubricants, etc. Generally the mechanical side of Formula One.
GhostF1
GhostF1
110
Joined: 30 Aug 2016, 04:11

Re: Honda Power Unit

Post

Vandoorne doing well. Engine also sounds very different again. Has a similar rasp as the Renault engine when its wastegates open.

GoranF1
GoranF1
155
Joined: 16 Dec 2014, 12:53
Location: Zagreb,Croatia

Re: Honda Power Unit

Post

If only the new spec has a small quali mode.....Alonso would enter Q3 in Barcelona.
"I have no idols. I admire work, dedication & competence."

User avatar
etusch
131
Joined: 22 Feb 2009, 23:09
Location: Turkey

Re: Honda Power Unit

Post

q2 at qual and as race position 8 or may be 7th finish is good enough for this stage

User avatar
RZS10
359
Joined: 07 Dec 2013, 01:23

Re: Honda Power Unit

Post

mattia.bobbo wrote:
13 May 2017, 11:07
Don't know if somebody already told that, but Alonso PU was brand new. And it lasted 1km
It wasn't new.

After Russia he was on (ICE, TC, H, K, ES, CE)
2-3-3-2-1-1

Check the technical reports for friday. He was still on the same parts.
http://www.fia.com/events/fia-formula-o ... rmation-21

The current engine is completely new, now:
3-4-4-3-1-1

User avatar
MrPotatoHead
53
Joined: 20 Apr 2017, 19:03
Location: All over.

Re: Honda Power Unit

Post

amho wrote:
13 May 2017, 03:22
godlameroso wrote:
13 May 2017, 01:50
More efficient combustion means less heat for the turbine, less heat for the turbine, less energy to potentially harvest. Less energy to harvest means less ERS deployment, less ERS deployment means less power.
I think that more efficient combustion does not neccessarily means less heat for turbine, more efficient combution might also means extracting more heat from a given fuel so higher pressure of combustion product to move piston and also as for turbine.
In a case that exhaust valves remain closed for a longer period during expansion stage then u have more efficiency and less remaining exhaust gas pressure for turbine which I don't think this is used for these high revving engines as u know in high revolution it's better to open exhaust valve earlier to have a longer exhaust duration.
There are indeed different ways to achieve more thermal efficiency.
Efficiency in its simplest form means how much energy (heat) are you extracting from what you put in. So without knowing how they got there it's very difficult to know if there will be more or less turbine energy available. There could very easily be more energy available to drive the turbine. Something to think about.

While on the talk of efficiency here's a fantastic video from the NASCAR world that directly relates to this discussion.
If you haven't seen it before it's well worth the 45 minutes or so to watch it.


Tommy Cookers
Tommy Cookers
642
Joined: 17 Feb 2012, 16:55

Re: Honda Power Unit

Post

[quote=MrPotatoHead][quote=amho]
I think that more efficient combustion does not neccessarily means less heat for turbine, more efficient combution might also means extracting more heat from a given fuel so higher pressure of combustion product to move piston and also as for turbine.
In a case that exhaust valves remain closed for a longer period during expansion stage then u have more efficiency and less remaining exhaust gas pressure for turbine which I don't think this is used for these high revving engines as u know in high revolution it's better to open exhaust valve earlier to have a longer exhaust duration.[/quote]

........So without knowing how they got there it's very difficult to know if there will be more or less turbine energy available. There could very easily be more energy available to drive the turbine. Something to think about. .....[/quote]

(TJI or similar meaning combusting efficiently a leaner mixture than could otherwise be combusted efficiently)
ie more air and so lower peak temperature so less energy thrown away to coolant so more energy in-cylinder for expansion
but the boost and exhaust pressures will be higher so the exhaust valves won't be opened later
exhaust temperature is lower but the greater expansion ratio across the turbine is surely quite helpful
Last edited by Tommy Cookers on 13 May 2017, 14:48, edited 2 times in total.

User avatar
MrPotatoHead
53
Joined: 20 Apr 2017, 19:03
Location: All over.

Re: Honda Power Unit

Post

Tommy you are on the right track in your thinking.
Remember these engines are fuel flow limited. So they are all going to use the same amount of fuel - but if you can run leaner then you have more air volume for the same fuel - thus more volume coming out of the exhaust valves.
And you are correct - if you reject less energy though heat loss then you will
Make more power and be more thermal efficient and also have more heat energy going out the exhaust.

The above is overly simplified of course.

As far as valve event timing on a turbo engine I think you'll find they have a lot lower overlap and this duration than the NA engines that preceded them. You don't / can't rely on exhaust scavenging to help you like on an NA engine.

Tommy Cookers
Tommy Cookers
642
Joined: 17 Feb 2012, 16:55

Re: Honda Power Unit

Post

well running little overlap allows more true back pressure (a -dP) without affecting in-cylinder conditions via internal EGR
that would boost recovery at some cost in ICE power
and all the similar 'heat dilution' engines in test and service seem to use about 0.5 bar true back pressure (but don't do recovery)

wouldn't we like to know boost and valve timings !

User avatar
MrPotatoHead
53
Joined: 20 Apr 2017, 19:03
Location: All over.

Re: Honda Power Unit

Post

Tommy Cookers wrote:
13 May 2017, 14:34
well running little overlap allows more true back pressure (a -dP) without affecting in-cylinder conditions via internal EGR
that would boost recovery at some cost in ICE power
and all the similar 'heat dilution' engines in test and service seem to use about 0.5 bar true back pressure (but don't do recovery)

wouldn't we like to know boost and valve timings !
Absolutely. The dynamics of a boosted engine are complex to say the least. Adding in ERS raises that complexity by an order of magnitude.

I could probably find out the numbers but even if I did I wouldn't be allowed to post them here. So we will have to stick to speculation and guesswork 😉

harjan
harjan
8
Joined: 05 Dec 2016, 08:28

Re: Honda Power Unit

Post

Wow. This will be huge boost for the team and partnership. Great work by Honda, McLaren and Alonso.

User avatar
MrPotatoHead
53
Joined: 20 Apr 2017, 19:03
Location: All over.

Re: Honda Power Unit

Post

harjan wrote:
13 May 2017, 14:42
Wow. This will be huge boost for the team and partnership. Great work by Honda, McLaren and Alonso.
Alonso always gets 100% of what's possible from the car. I hope we see him with equipment soon to win again.
And I hope that is with McLaren Honda.

Sonador
Sonador
3
Joined: 06 May 2016, 17:26

Re: Honda Power Unit

Post

harjan wrote:
13 May 2017, 14:42
Wow. This will be huge boost for the team and partnership. Great work by Honda, McLaren and Alonso.
Finnaly some smiles at the Mclaren Honda garage!

harjan
harjan
8
Joined: 05 Dec 2016, 08:28

Re: Honda Power Unit

Post

Off-topic: YES YES YES YES

User avatar
loner
16
Joined: 26 Feb 2016, 18:34

Re: Honda Power Unit

Post

loner wrote:
11 May 2017, 20:58
HPD wrote:
11 May 2017, 20:38
@Albert Fabrega

- Honda comes with updates that do not require tokens.

- There is new fuel.

- The problem of alonso in russia, was located and solved, did not affect any part of the engine.
this is for sure the post Bahrain changes they will mix it in the midfield i think...
:wink: :wink:
para bellum.

User avatar
MrPotatoHead
53
Joined: 20 Apr 2017, 19:03
Location: All over.

Re: Honda Power Unit

Post

Hopefully the Honda can last the race at top ten pace and not just qualifying laps!
7th place. Good job Alonso!