Here you go:diffuser wrote:I haven't seen,couldn't find it.SmallSoldier wrote: ↑17 Feb 2021, 23:37They were allowed to modified the length of the car due to the installation... They had to change the gearbox bell housing to a longer one.diffuser wrote: Problem with that picture is it show's the front structure of MCL35M is longer than MCL35 and that would required tokens to change so the picture zoom is different between the 2 halves.
Not as sure but I was under the impression that they couldn't use the tokens to change the length of the back either.
I don’t understand why you wouldn’t even take Key’s comments as proof of it when he explicitly said so... Beyond the pictures posted here... In the image posted the tires are scaled up pretty even... And even if there is an small difference, the increase is too big at the rear to justify for it... In regards to the nosecone... The picture comparison is against the launch spec MCL35, therefore with the stub nose instead of the slim one which could account for some of the visual difference
Sent from my iPhone using Tapatalk
The bell housing would have been shorter not longer, I think. The Compressor on the front of the Motor makes the PU start a little further back ....
https://www.mclaren.com/racing/2021/car ... y-changes/
Exact quote:
Nevertheless, the switch to Mercedes power has resulted in a new chassis; gearbox; and fuel, hydraulic, electrical and cooling systems. Even the wheelbase has changed: we’ve had to extend it slightly because the gearbox bell housing is longer to accommodate the Mercedes engine.
Sent from my iPad using Tapatalk