Tommy Cookers wrote: ↑23 Jun 2021, 15:58
high power via big engine or small ? - Tresilian's design studies (for RR ?) showed much smaller engines as better
J.A.W. wrote: ↑24 Jun 2021, 12:20
Well T-C, sure seems like R/R 'hard-head' Hives didn't buy Tresilian's hype any more
than he did any of the other X-crank R/R engines he'd serially stymied/cancelled...
Tresilian was proposing a X-16 2-stroke, based on Crecy principles, utilizing the Griffon supercharger and an exhaust gas recovery turbine as an alternative to the AP25 gas turbine Rolls-Royce was developing at the time. Both were to deliver 2,500hp.
The Tresilian design was never developed beyond some calculations, and the AP25 was ditched in favour of pure jet engines.
I wouldn't read too much into the Tresilian design being cancelled/not developed. They dumped the Crecy pretty soon after the war as well*.
Of the other Rolls-Royce X engines:
The Eagle XVI was developed by Henry Royce as his preferred alternative to Curtiss D-12. It was developed in parallel, with fewer resources, to the F, which became the Kestrel. Airframe manufacturers preferred the narrower V-12 F. The Eagle XVI was 19.8L vs F/Kestrel's 21.2L.
The Vulture, the only X-type engine of Rolls-Royce's to make production. Reliability issues slowed development, and it was probably deployed too early. Development was suspended, along with most other RR engines, at the time of the Battle of Britain, so that resources could be spent improving the performance of the Merlin. Development freeze also affected the Griffon, btw. In 1941 several programs were cancelled, including the Vulture. It had, however, been successfully run at 2,500hp prior to cancellation. The big problem for the future of the Vulture was the lack of airframes that would use it in the meantime. The Griffon offered more, basically because it could be made to fit in a Spitfire.
The Exe was an X-24 sleeve valve, air cooled 4 stroke of 22L. It was also heavier than the equivalent Merlin (not including radiator), and the power potential was limited by its size.
The Pennine was an X-24 sleeve valve, air cooled 4 stroke of 46L. Designed for post war transport use it demonstrated power of 2,800hp. It was not developed further as Rolls-Royce had turned their attention, for the most part, to gas turbines. The Pennine negated one of the Vulture's failings by using a single piece master rod and a built up crank - somewhat common practice in big radials.
* The Crecy would have been dumped in 1941 had Hives had his way. But Rolls-Royce were required to proceed with development by the Air Ministry, though not a lot of resources were thrown at it.