reminds me of Baku last year...
They really should have, it was bad decision making by them. It obvious when Yuki was so close, esp in sector 2. They should have known the new floor wasn't producing the desired performance. To not test it in fp3 is a big question mark for the team.
The car will be slightly higher in the race because they will be going slower through there. So maybe the ride height is more suited to the race but was too low for qualifying.Badger wrote: ↑26 Oct 2025, 00:22Car looked very mediocre all day. Bottoming out like crazy in S2. Maybe running that low will help in the race but it certainly didn’t in quali.
It’s gonna need a lot of luck now. Lando has 4 hungry sharks on his tail going into T1. If he survives the start it’s game over.
Fingers crossed!!AR3-GP wrote: ↑26 Oct 2025, 00:23The car will be slightly higher in the race because they will be going slower through there. So maybe the ride height is more suited to the race but was too low for qualifying.Badger wrote: ↑26 Oct 2025, 00:22Car looked very mediocre all day. Bottoming out like crazy in S2. Maybe running that low will help in the race but it certainly didn’t in quali.
It’s gonna need a lot of luck now. Lando has 4 hungry sharks on his tail going into T1. If he survives the start it’s game over.
As I feared, they bit more than what they can chew. The hope was nice while it lasted. Anyway, it was worth a try.venkyhere wrote: ↑24 Oct 2025, 19:38AR3-GP wrote: ↑24 Oct 2025, 19:12The cooling stuff tends to be mexico specific. It is therefore planned well in advance and common for most teams. I've heard that the floor stuff is just CFD going straight to track as it's not a revolution, it's just refinement. The RB21 windtunnel model has been collecting dust for a while.venkyhere wrote: ↑24 Oct 2025, 19:06Reading the published datasheet of the changes, looks like A LOT for the (N-4)th race of the last year of a regulation. This is the engineering team in full-on attack mode (probably planned 4-5 months ago). However, I won't get excited just yet, will wait until end of FP3. The team has a not-very-old history of 'upgrades' ending up as 'updates' , hopefully not this time.
Yes I did understand from the document that the changes are circuit specific cooling needs and the floor revision. My surprise is that they are going ultra-aggressive with the shape of the floor tunnel ('lowered uoper floor surface') - unsure whether it is fore or aft of the venturi neck, apart from a 'sidepod revision' that is mentioned as well. I rather expected some edge wing changes only, to clean-up/modify the edge vortices. This is like a 'main' change. Hence my comment.