From Renault(BP) and RB(MobilExxon). "MobilExxon fuel has a performance gain over BP"
Racer.com had a story about it today.
'The fact that Renault has switched to BP/Castrol while RB is working with Mobil does not yet appear to be a problem for engine development. Marko says, however, "If there are problems with reliability, it could be a disadvanage". On the single-cylinder test bench no significant difference has been seen so far'
What form does that performance take?
HP is stated for all you peeps because that is all the press understand and thinks you only understand.This engine formula isn't about HP.So HP is used as a performance guide between each PU but it isn't a correct guide for performance of each PU.
For sure, it may have more energy density (more combustion energy per kg of fuel, so peak hp may not increase but average hp during race may be higher), it may have more mass density (so smaller tank to hold 100 kg). The fuel may come with $10 million in sponsorship which clearly leads to performance gains.
HP over a range? Then would it make more sense to talk about broader torque curves, or longer full power deployment to the MGU-K?
You mean Gilles Simon and the FIA?godlameroso wrote: ↑18 Jun 2017, 19:43The restrictions are in theory to keep costs down, but in practice make catching up to the rule writers more difficult.
Peak HP would also increase unless there was some other limiting factor.
He left the FIA in mid 2011 to join PURE.godlameroso wrote: ↑19 Jun 2017, 02:41Did he? That's very interesting. He joined PURE in 2011, and he was a consultant to Honda since 2013 until his recent departure, but I didn't know he was involved in the engine regulations. So that means that the current formula was drafted around 2009 when he was involved with the FIA?
That picture does not show what you think it does.PlatinumZealot wrote: ↑17 Jun 2017, 15:40Very wrong. They have the full chassis dynamoteter. In this 2015! Article you can see they even use it for super formula...MrPotatoHead wrote: ↑15 Jun 2017, 03:36From what i can tell Honda have a full AVL track simulation dyno system.
But it is a rigid test stand type system not a full chassis simulation.
If they are still having vibration issues the chances of finding the solution on the dyno without a full chassis simulation is pretty slim.
But it's important to remember that a 90 degree V6 with straight crank pins will always be an odd fire engine and will inherently be vibration prone.
http://www.somersf1.co.uk/2015/09/mclar ... d.html?m=1
They have all sorts of dyno types and brands it seems..
This photo was years ago but they surely have upgraded since then.
http://4.bp.blogspot.com/-AHntp4Y7Wrs/V ... ura_09.jpg