or just comparing data...
They already have data to compare from yesterday. They used the bulged one in FP1 and the wider one in FP2.
according to the rule the use of two waste gates requires each having their own separate dedicated exhaust pipe.PlatinumZealot wrote: ↑21 Jul 2018, 13:57The bottom pipe doesnt seem necessary for flow capacit barely any flow would go though it at that 90 degree branch. Likely there for legal reasons. Maybe two pipes are required by the regs and Ferrari only need one.
could it be a resonator/expansion chamber ? not sure yetroon wrote: ↑21 Jul 2018, 01:48I wonder if the lower pipe entrains flow into the upper pipe.
https://i.imgur.com/F1DqvnV.jpg
Edit: this may violate:
So it may just be about raising the height of the topmost pipe, or altering exhaust pulse timing out of the wastegate pipes. The lower pipe being maybe 80mm longer (length of elbow).5.8.2 Engine exhaust systems must have only a single turbine tailpipe exit and either one or two wastegate tailpipe exits which must all be rearward facing and through which all exhaust gases must pass. All and only the turbine exit exhaust gases must pass through the turbine tailpipe and all and only the wastegate exhaust gases must pass through the wastegate tailpipe(s). None of the tailpipes may be contained within any of the other tailpipes.
paddyf1 wrote: ↑22 Jul 2018, 21:10https://www.youtube.com/watch?v=PWHGZp2UyZw&t=0s
25 second mark. I think it was the same bit that eventually fell off.
Makes sense to me. Reduce the intensity of the exhaust pulses, create smoother flow. If I understand the working principals correctly.jagunx51 wrote: ↑22 Jul 2018, 13:47could it be a resonator/expansion chamber ? not sure yetroon wrote: ↑21 Jul 2018, 01:48I wonder if the lower pipe entrains flow into the upper pipe.
https://i.imgur.com/F1DqvnV.jpg
Edit: this may violate:
So it may just be about raising the height of the topmost pipe, or altering exhaust pulse timing out of the wastegate pipes. The lower pipe being maybe 80mm longer (length of elbow).5.8.2 Engine exhaust systems must have only a single turbine tailpipe exit and either one or two wastegate tailpipe exits which must all be rearward facing and through which all exhaust gases must pass. All and only the turbine exit exhaust gases must pass through the turbine tailpipe and all and only the wastegate exhaust gases must pass through the wastegate tailpipe(s). None of the tailpipes may be contained within any of the other tailpipes.