Henk_v wrote: ↑05 Mar 2024, 18:57
Did anyone notice the floor stays do not connect to the floor but the edge wing?
Looking at the wing seperation brackets placement they seem to target some flexure benefit. That would be very smart.
When measured, the floor edge is very stiff due to te stay, but the floor and wing itself might be quite flexible. Suction Will suck the floor down and cantilever the wing up
The stay was actually connected to the edge wing since 23 Barcelona Evo spec
Later floor specs then fully integrated this into 1 common bracket and the edge wing started forming a continuous outer edge surface with the rear corner, thus only leaving the lateral slot gap
It's a legality slot now, yes